When the forecast turns and your event calendar doesn’t, you don’t have time to wait on heating gear. We built our infrared tent heaters for that exact pressure—the moment when a chill starts to nip at guests and throw your setup off rhythm. Our approach is simple: make design choices that cut lead time, and keep manufacturing lean so units ship the same day you order. What matters, technically We lean on short-wave infrared because it delivers radiant warmth fast—heating people and surfaces directly, not the air. The heart of it is a quartz tube paired with a reflector that throws the output forward, so the heat lands where you need it. In real life, you feel it within seconds, not minutes. Depending on the model, these run on standard 120V or 240V. They’re built with an IP rating for outdoor use, and safety is baked in with tip-over protection and a thermal cut-off. For control, an adjustable thermostat lets you dial the output to match the tent size and the crowd. Why this works in tents Tents are thin-skinned—wind shifts everything, and air temperature can swing fast. Electric infrared heat sidesteps venting headaches and holds steady without drying out the space. For event pros, that means fewer call-backs, fewer cold spots, and fewer last-minute swap-outs. Here’s how we keep things moving: we stock the key components and run assembly in parallel, so production doesn’t stall while you’re on a deadline. The upshot is a heater that shows up fast, sets up fast, and keeps the tent comfortable from the first guest to the last. Things to keep in mind Because infrared heats objects first, placement matters. Position the heater so the beam covers seating or work areas, and keep clearances clear—typically three feet or more, depending on the model. Match the unit’s power to your tent size, and if you need it, use an outdoor-rated extension cord. Plan for condensation, too. A well-vented tent with a vapor barrier helps keep moisture from building up. If you’re running multiple heaters, we can pre-set thermostat ranges before shipment, so you can plug in and get on with the job.